1) If you own a Laurastar ironing system （such as S4a, S7a, Pulse Silve and Smart）:
- To switch off your Laurastar, press the on/ off switch and unplug the appliance.
- Remove the iron protective soleplate when it is still hot and place it on a heat-resistant surface. Clean it once it has cooled down.
- Put away the hot iron in its security box and close it.
- Remove and place the steam cord holder in its horizontal position.
- Adjust the board to its highest position, fold it and store it away.

Tip: Check for any condensation under the cover before tidying it away and leave it to dry, if necessary.
Warning: if the ironing system is stored away face up, the cold water tank must first be emptied.

2) You possess a steam generator Laurastar Lift, Laurastar Lift + or Laurastar Lift Xtra:

- Switch off the appliance by pressing the on/off switch and unplugging the plug from the outlet.
- Let the steam station cool down for at least 2 hours before storing it away. Water can be left in the tank until the next use.

To store it away:
- Remove the iron protective soleplate when it is still hot and place it on a heat-resistant surface. Clean it once it has cooled down.
- Place the insulating mat back on the station, then the iron.
- Roll the electric cable, as well as the steam cord around the appliance. For the Laurastar Lift + or Lift Xtra models, pull on the electric cable to activate the automatic roll-up and wrap the steam cord around the appliance.